PDA

View Full Version : Looking for a local engine builder


Corbin
July 7th, 2018, 10:59 PM
So not only am I a new Falcon owner, I'm also new to Washington. That said, I'm looking for recommendations for a local engine guy that can build a carb to pan 347 setup along with a dyno sheet/tune.

I'd really hate to spend this kind of money based off of Google and Yelp reviews. Hoping some of you can share your experiences with local builders.

As far as the engine goes, I'd like to get as close as possible to 400rwhp through a C4 and pump gas.
Corbin
July 10th, 2018, 07:44 AM
So I just noticed that I probably should've posted this in the Local Resources. I tried to delete the post but I am not seeing an option for that.

My apologies.
Luva65wagon
July 11th, 2018, 10:32 AM
I've used a couple places recently, but have the most experience with Action Machine in Shoreline. Rob has been there as long as I've lived in WA (about 40 years) and has always been helpful. He also builds race motors as I ran into him up at the drags one time I went.

Most recently I (along with Smithkid AKA Gene) built a 351 motor machined by a shop in south Everett. Name eludes me at the moment, but it's right about 212th and Hwy 99 in Everett.

Comparing these two shops is like night and day (AM is a pristine shop and the other is... well, not) but the work I saw from both was very good.

Hope this helps.
Corbin
July 11th, 2018, 10:37 AM
That does help. I appreciate the feedback. I've spoke to a few shops and didn't get the warm fuzzy feeling, so I moved on.
Corbin
July 24th, 2018, 07:07 AM
Little update.

I've decided to go with Randy over at Johnson's Machine & Performance. After many conversations, I get the warm fuzzy feeling. Nothing but praise in regards to online reviews. Seems to be very knowledgeable and is experienced with the 331/347. Going to swing their shop today to finalize the specs and start the build.
sdkunick
May 14th, 2020, 09:48 PM
So I’m in your shoes just 2 years later. Did you do your motor and were you happy with the shop?

TIA

Steve Kunick
Box stock 64 Sprint
dhbfaster
June 10th, 2020, 12:08 PM
FYI, if you want a “standard” full rebuild, you might think about S&J Engines in Spokane.
Shipping round trip was only $100 and I got my same original block back totally remanufactured.
They did the whole job in a week and the price was great.
dhbfaster
June 10th, 2020, 12:17 PM
FYI, if you want a “standard” full rebuild, you might think about S&J Engines in Spokane.
Shipping round trip was only $100 and I got my same original block back totally remanufactured.
They did the whole job in a week and the price was great.