All Points Bulletin. Rocker arm assembly needed

[Nathan289]

Hello,

So motor is all rebuilt.. good compression, good oil psi.

Has a rattle or even a knock almost..

So I check this and that and have just about eliminated everything until Roger and my machinist say check the rocker arm shaft..

So needless to say mine is bent has a bow in it. And is scored really bad from lack of oil or whatever..


So I need a rocker arm shaft assembly for a mechanical lifter setup..

Shoot me a pm if anyone has a spare

[Luva65wagon]

Nathan - I found one, but it's not the good one I had - so it is probably on a Comet, best guess.

I have it boxed up and will ship it to you tomorrow and hopefully you can use it.

[Nathan289]

Roger,
Thanks..

I got mine all measured this morning.

The shaft is .769 or .011 below specs plus it bent.
I have 10 rockers that are use able and I have 2 that are at limits.

Worst case scenario I could buy a new shaft and scavenge a couple rockers from yours.

What do I owe you for shipping?

[Luva65wagon]

Don't worry about it. I suspect someday I'll need something you have and you can return the favor. I hope there are good bits on it for you.