malodin
July 10th, 2014, 06:21 AM
This is my 69 falcon, has a mexican block 302/c4 was a 3 speed on the tree, the p.o. just hooked the linkage up to the auto transmission(i have an auto column for it). I parted out another 69 2 door when i first bought this one and have all black interior for it along with bucket seats and extra hood/fenders/doors/trunk.
i have a 1988 5.0 roller motor that was built with an aod i plan on installing in it along with the rear 8.8(possibly)
these pictures with the sandblasting were taken last thursday. I got tired of looking at the rust and wanted it to stop so i just sandblasted it down and hit it with a coat of self etching primer than some heavy duty grey i had in the shop. Yes its rattle can but I am in no position to start the body work just yet. I only found a couple small patches of bondo on the passenger side rear wheel well, and the passenger side lower body line behind the rear wheel well was about 1/16" thick the entire panel(not sure how bad it is wrinkled).
i have a 1988 5.0 roller motor that was built with an aod i plan on installing in it along with the rear 8.8(possibly)
these pictures with the sandblasting were taken last thursday. I got tired of looking at the rust and wanted it to stop so i just sandblasted it down and hit it with a coat of self etching primer than some heavy duty grey i had in the shop. Yes its rattle can but I am in no position to start the body work just yet. I only found a couple small patches of bondo on the passenger side rear wheel well, and the passenger side lower body line behind the rear wheel well was about 1/16" thick the entire panel(not sure how bad it is wrinkled).