heater hose help

[Nathan289]

Ok, my simple carb and intake swap snowballed into whileimatit iteis.
Ended up pulling the water pump and timing cover. While I'm at it I should check out this timing chain. Yup needs one. While I'm at it I wonder if a cam and lifter swap will help my performance. What a cam and lifters is only $100? for name brand USA made stuff.shoot I'll do that too. When's the next time I'll have the motor opened up?

So I'm getting all back together. Had to work out the throttle linkage. Started installing a dearborn classic fan shroud. What a POS that is. If that's an exact copy of the original I know why no body put them back on. So I installed a larger and more blade fan.

The problem I have is the heater hose routing. Which hose goes to the top fitting? My v8 supplement doesn't show or list crap. Looks like I need to order a 64 manual to get real v8 info.

Nathan

[redfalken]

Hey Nathan,

Are you talking about the fitting to the heater core? If so, I don't think it matters.

[SmithKid]

Only differance would be the direction of flow thru the heater core. Shouldn't matter.

[Nathan289]

Kenny,
Yes the heater core fittings.
It might not matter but I thought the heater worked better routed one way over the other.

If my thinking is correct the top hose comes off the intake manifold behind the thermostat. That's where the hot water should come from.
It enters the top of the heater core and cools like a radiator and leaves through the bottom hose to the water pump which should be sucking the coolant from the heater core.

In fact I'm going to hook it up that way.. just need a non leaking heater core.

Nathan

[SmithKid]

Your logic seems correct to me. Maybe I should have been paying more attention. I've never worried about it. Maybe I could have been warmer in the winter!

[Nathan289]

What frustrates me is I went out and bought the 63 supplement only to find no v8 stuff in it. So I bought a new reproduction shop manual that is supposed to include the v8 section, which it does but its mostly just information on the v8. It doesn't actually show you how to fix anything.
So it looks like maybe a 64 manual will contain more info?
I had to use an old mustang manual on how to adjust the hydraulic valves. Didn't see anything on heater hose routing though..

Now I need to inspect that heater core that i scored from the junkyard Saturday.
Hopefully it wasn't leaking.

Nathan

[Luva65wagon]

Nathan,

The factory recommended routing:

V-8 "manifold hose" up over the carb choke housing (if applicable) and on to the bottom hole in the firewall to the heater core. The top hose from the heater core goes through the top hole in the firewall and is routed straight to the water pump fitting.

[redfalken]

Kenny,
Yes the heater core fittings.
It might not matter but I thought the heater worked better routed one way over the other.

If my thinking is correct the top hose comes off the intake manifold behind the thermostat. That's where the hot water should come from.
It enters the top of the heater core and cools like a radiator and leaves through the bottom hose to the water pump which should be sucking the coolant from the heater core.

In fact I'm going to hook it up that way.. just need a non leaking heater core.

Nathan

I think that's how mine are on the six. Hot water enters the top. Sounds logical but mine are that way because the hoses drape better in the engine bay! :D

[Nathan289]

Gene,
Just because it makes since to us doesn't mean it made since to ford.
We would have routed our hoses wrong.

Thanks Roger,
May I ask where you found that info? If it was in a 64 manual I'll add that to my shopping list.

I might install them backwards because like Kenny, I think they drape better in the engine compartment.

Nathan