Ignition switch question

[Elhot]

Hey all,
I've just replaced the ignition switch in my 65 Ranchero and have a question about that little pin that holds the key tumbler in. Mine fell out and vaporized as I initially pulled the piece out. So my question is what is a good replacement for it ? And what length? Any tips on reinstalling that tumbler and pin would sure be appreciated. The manual is rather vague. Love this new format!
Thanks in advance
Elliot

[Sedanman]

Hi Elliot,

I remember the same thing happened when I pulled the ignition switch out of my dad's mustang - and it never went back in right and has not been fixed yet :rolleyes: I thought the tumbler was part of the ignition switch so I'm a bit confused, but those are available new (same as a mustang). Of course that means an extra key or replacing the door locks too- not exactly the answer you wanted! I'll dig through my parts bin as I may still have the switch from my '65 wagon parts car.

[Sedanman]

Elliot,

I looked at my '65 wiring harness today and the switch is not there. I still have the "tumbler" and key, but don't see any pin there and don't remember seeing one when I pulled it out.

If I have time this weekend I'll pull the switch out of my current car to examine the pin you're missing. Where is the pin located - is it part of the chrome sleeve that the tumbler goes into, or should it come out in the tumbler? When I took the one out of the mustang so many pieces came out I didn't pay attention to what they looked like!

[Elhot]

Thanks for stopping by the shop today it was fun to show you the new projects. And thanks also for your offerings of help with that pin. As I told you today that pin is permanately located so it was there all the time.
Take care man ,Elliot