The new ECU is mounted. It's mounted to the backside of the firewall right above the heater box. This is a big upgrade from the crappy attempt to mount the prior ECU with velcro. You can see the old velcro above in one of the photos. It will be a shore wire run from the back of the new bulkhead to the ECU. This should keep the wiring clean.

Falcon_ECU_Mounted_1.jpg

Falcon_ECU_Mounted_2.jpg


I'm installing a new battery hot wire as part of the cleanup. There was a factory yellow with black stripe on the old bulkhead. I'm keeping the original yellow. There are now two 12G TXL yellow wires connected to a MRBF 30A fuse. I used 12G because it's the largest that will fit the new bulkhead. I'll take the two 12G wires and splice them to a single 10G under the dash.

Falcon_30A_Fuse.jpg