Pictures or info needed

[Loren]

Thanks for the pic Jeff. I have basically the same setup for my back up lights, but as you said the power window wiring is much bulkier. I see a small hole drilled in the body above rear bumper seal beside the grommet the wiring goes thru, but I don't know what clamp to use. As I said before I don't want to scratch the paint when I open and close the tailgate. The wiring sticks out in the gap between the tailgate and the body when the gate is closed without being clamped. Thanks again......Loren

[Luva65wagon]

Well, Here's another image I found. Looks as though there is a long hold-down bracket screwed to the bottom of the tailgate and there is a small clip just out of view at the body. Still haven't found specifics. but will keep looking as I can.

[Loren]

Thanks Roger. That's what I am looking for. It looks like I can make up a bracket and that should control the wiring. At least is gives me a start......Loren

[Luva65wagon]

Awesome deal! Show us what you create! Might help someone else someday.

[Loren]

Will do when I come up with something. Thanks again.

[Loren]

Hi Roger. This is what I have come up with. It's not the prettiest, but it serves the purpose until I can find the original brackets or build a bracket myself.

Backup light wiring.JPGPower window wiring.JPGTotal tailgate wiring.JPG

[Luva65wagon]

Looks fine to me Loren. I agree with you it's maybe not as nice as an original bracket might be, but for sure they won't rust! Especially if you used stainless screws.