I also have used Aalbu Bros. in Everett. This was quite a few years ago, but I was satisfied with their work (I added a leaf).
Senior Forum User
I also have used Aalbu Bros. in Everett. This was quite a few years ago, but I was satisfied with their work (I added a leaf).
Gene Smith
Fredrickson, WA
'65 Ranchero Deluxe
302, EFI, 4-Spd
Granada Discs
Senior Forum User
All right Pat, I set the van up at the ride height I want and took some measurements. It looks like the coil height will be about 7" at ride height but can go below 3" to over 10". According to their documentation I'll need to use a F6908 Double Convoluted under frame mount. Thoughts?
Last edited by pbrown; April 16th, 2012 at 11:15 PM.
Brian
'67 Falcon Bus/240/C4/Offy DP/MSD Duraspark II/Holley 4160
Administrator
That seems right to me. Is the spring inline with the frame rails? No offset?
Patrick Brown
331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI
Senior Forum User
No offset, they sit directly below them. The rear shackles bolt right to the frame.
Brian
'67 Falcon Bus/240/C4/Offy DP/MSD Duraspark II/Holley 4160
Administrator
Are you going to do the rear at the same time?
Patrick Brown
331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI
Senior Forum User
I was not planning on doing the rear, that seems to be fine as is.
Brian
'67 Falcon Bus/240/C4/Offy DP/MSD Duraspark II/Holley 4160
Posting Permissions
Reply With Quote
Bookmarks