It's looking good so far. Are you going to remove the wiring harness and the rest of the small bits?
I'll bet you have a rust issue in the cowl. It wouldn't take much effort to pull the cowl vent. Get a spot weld cutter and drill out the welds and it will come off. Then cut out the bad and weld in new steel.
What are the plans for this one? L6? V8? Turbine? What suspension? Tranny?
Patrick Brown
331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI
Looks like all the wiring is out of it... that last picture I think was a "before" picture. But it does look like the strut-rod nuts might be unwilling to come loose... and maybe the screws holding on the striker plates. Kroil, I say.
I was going to ask as well whether you were able to ascertain the condition of the cowl? I started to drill those out on a Ranchero had once and after starting to drill out about 100 spot welds I decided to abandon the car before I got that far. I wonder to this day if anyone ever go it to the place you are at here. Keep up the progress pics!
Picture this. Paint the delivery satin black. Not flat, you want a bit of shine. Lower it a couple of inches to get the right stance. Add red pin-striping and make up a garage name for the panel area. Make it look like a vintage shop truck. Better yet, use your own business name.
Wow you guys have a good eye. The strut rods finally came loose. Lots of free-all and a few (lots) of 4 letter words. The sedan is stripped now and I have cut out the back cargo floor area, and the passenger floor area. I will cut out the drivers floor next and then it is down to the shop for a media blasting session.
The cowl area is not too bad, except for the passenger side. The ring is rotted out but the rest looks pretty solid. If this was not a rare car (1 of 113) I think I may have reconsidered the rebuild. But I have wanted one for 15 years so I am going for it.
I like the idea for paint. I started that way, but the wife wants blue with the panel in a silvery gray color?? I haven't made up my mind. She has her car so this one is mine. The powder coating shop logo is definitely going on the side.
Any how I will shoot a couple of more pics so you can see how much is cut off the car at this point and keep you all posted. Thanks for the support and input. Steve H.
Was looking at the post again and I missed a bunch of questions.
OK, I like the wheels those are going to the top of my choices list. i want something cool but not over used.
As far as the build; 347 stroker, AOD trans, 9" rear posi 4:11 gears. I am still on the fence for suspension. I ahve had a few good options from you guys so far just not sure if I am going with springs or air bags? Not sure on the steering yet either. Do I leave it stock or go with a rack and pinion?? I am going simple with the brakes. Disk front drum rear. I will keep the original trans just in case but the motor is a 200 6cly not the 144 so I will get rid of it. I'll keep the rear axle around as well, that way I can go back to original if the car becomes worth millions. (haha)
Anyway that is the plan so far. Look for more pics tomorrow with big hole in the floor area.
Ok here are some updated pics I took last night. I looked at removing the cowl piece. Wow that looks like a big job. Inner fenders dash and firewall all need to come loose??? Maybe I need to find an easier way to do that part. Any ideas???
Bookmarks